69-96 Convertible Rear Mount
- Screw latching bolt into Flag Caddie two turns. Align groove with rear latch rod and push down until
it latches then lift and tighten Flag Caddie.
- After Flag Caddie is securely mounted, firmly grasp flag mast and seat fully into Flag Caddie.
(Approximately 3/4 of an inch)
Note: When releasing, unscrew Flag Caddie 1/2 turn, hold Flag Caddie, then pull latch release lever.
|
 |
84-96 Coupe Front Mount
- Insert No. 40 TORX wrench (Supplied with car) from
bottom side of roof mounting bolt, push bolt up then
tighten Flag Caddie onto bolt. (Caution: Do not over
tighten)
- After Flag Caddie is securely mounted, firmly
grasp flag mast and seat fully into Flag Caddie.
(Approximately 3/4 of an inch)
|
 |
86-96 Convertible Front Mount
- Screw latch bolt into Flag Caddie eight full
turns. Align notches in latch bolt with windshield
roof latch mounting pins, then insert and tighten
Flag Caddie.
- After Flag Caddie is securely mounted, firmly
grasp flag mast and seat fully into Flag Caddie.
(Approximately 3/4 of an inch)
Note: When releasing, unscrew Flag Caddie
1/4 turn, then lift.
|
 |
97-01 Windshield Mount
- Insert thumb screw from bottom of windshield roof
guide pin, then screw on Flag Caddie until tight.
- After Flag Caddie is securely mounted, firmly
grasp flag mast and seat fully into Flag Caddie.
(Approximately 3/4 of an inch)
|
 |